Entries with no category-
Originally Posted by QuiltnNan
Originally Posted by jul12
I've had my 8900 just over 12 months. At first I nearly went mad with fmq - breaks and skipping. Then I got some Janome purple tip needles - end of problem.
Seems that the machine "bedded in" as it were, because after a couple of quilts, I returned to other needles. Have just finished a couple of heavily fmq'd quilts with J. titanium 70/10, and Aurifil 50 wt.
I've not done anything with bobbin tension, just have the machine on 'auto'.
But I have found that it will
Originally Posted by judy363905
Originally Posted by Kitsie
I use this method:
Kirstie... Thank you for posting the drawings ...so much better than my explanation (but I did try lol)
Judy in Phx, AZ
Originally Posted by PaperPrincess
This chart will work for Disappearing Hourglass and Disappearing Pinwheel blocks.
I wanted to make MSQC's disappearing Hourglass but don't care for the method Jenny uses to create the HSTs with bias edges and wanted to use yardage rather than Layer Cakes.
I also wanted to use sizes where the original cut squares, trimmed HSTs and 9 patch units would be cut on 1/4" increments. Didn't want to make a block that you needed to slice into 5 27/32" cuts! I put together an
Originally Posted by roolen
I will tell how I sewed blocks for that quilt - http://www.quiltingboard.com/t-50511-1.htm
My English is not too good but I will try .
I did not use special rulers for this block. I had only a triangular ruler and usual square ruler at my order.
I didi it anyway.
However, my pictures are detailed so I hope you will understand all only on photos.
All strips on pictures have width 1 1/2 inches, the size of squares is 4 inches.
Originally Posted by charismah
A lady came in and taught this to use a few months back at a long arm quilters meeting and I thought I would share. I am one of those people who do hand binding but when you are in a hurry and you need binding done fast..this is the way!
You will need two different colors for the binding strips
You cut the outer edge 1 3/8 you cut the flange peice 1 5/8 (inches)
Then sew them just like you would normal binding in one long strip ( short side ...to short side right
Updated 07-28-2014 at 01:27 AM by QuiltnNan
Originally Posted by QuiltnNan
This chart gives the hex size on the edge along with the overall width and height. It also tells what size strip to cut and how many hexes you can get out of fat quarter, yardage, etc.
I keep a folder on my hard drive called Quilt Ideas. It is in my Pictures section. If I see something Online, I take a Print Screen of it and paste it into my MS Paint program. I crop the picture to the pertinent facts and then save it by naming it by the date [ today is 20140720], then the source of the picture. That way, I always know where it came from and can give credit where credit is due. I can always find it again to post a link on the QB if I wish to share it in the future. For instance,
24 Blocks has a link to Quilting Board's Articles
Here is our article
Originally Posted by SlightlyOffQuilter
Honestly, I have yet to find ANY fabrics that will hold a photo unless I print them on my Grandmothers Epson printer. If I print it on my HP, NOTHING but black stays. This is because Epson inks are pigment ink ( permanent ) and HP inks are dye based ( water soluble ) . HP does make Vivera Pigment Ink. Make sure to check your ink to be sure it says PIGMENT and not DYE. A quick tell is if your printer uses 1 black cartridge and 1 tri-color cartridge your printer does not support pigment cartridges.