Entries with no category-
]For those of you having trouble resizing your pictures,
I HIGHLY recommend downloading, installing and TRYING
this image resizer.
I have been using it for several years (since I had Windows XP).
Its easy to use, just follow the steps on the website.
Good Luck and I hope if you try this it will work for you also.
Vintage sewing machine not stitching - very generic tutorial
Does it need a new needle? That is usually the quickest easiest cheapest fix. Change the needle... some times we hit pins or sometimes people pull the material through the machine and the needle bends. Sometimes needles get dull? When was the last time it was changed?
Make sure the needle is in all the way
Try this first. Take apart the throat plate then try putting it all back
Originally Posted by Phyllis nm
About 20 years ago I bought “new” leathers for my 104 and 114 machines and the leather was old I guess. They kept breaking, and I hate the replacing the clips. I went to my air condition/ plumbing supply and bought regular fan belts from them. I have never a problem since.
I called all over town and found one long and thin enough to fit my 29-4 but I had to cut it to get it on the machine. That was not easy to clip together
Originally Posted by jlhmnj
Treadle belt is pretty easy and instructions sometimes come with belt. Here's what I'd do if I didn't have the 3n1 treadle pliers:
---Get proper size belt in natural leather (stay away from red) from SM supply, ebay or.....
---wrap belt around treadle pulley and SM pulley and pull tight and cut where ends meet (don't worry about cutting short the belt will stretch)
---examine wire staple that comes with belt, get drill bit slightly bigger than staple diameter and drill hole
Originally Posted by Charlee
For those of you with cabinets that have finishes that are less than pristine, but not bad enough to justify a total strip/stain/shellac or varnish, this is what I do with my cabinets:
I went and bought "Howard's Restore-A-Finish", and a bottle of "Howard's Bees Wax and Orange Oil". It's very easy to use, you'll need some 0000 steel wool, and some soft rags. When you apply the R-A-F, use the steel wool and make sure to follow the grain of the wood...rub gently.
Originally Posted by Glenn
Yes, to much of the finish is gone for Howards to you any good. You have two choices, sand it down until the finish is removed then stain and apply two or three coats of shellac. You can also use denatured alcohol and lots of rags rag to remove the shellac without removing the original stain. If you need to even out the stain you can do this with stain of you choice I use aniline dye(water soluble) then apply shellac. If you want I can Pm you with instructions on applying shellac with a rag and
Originally Posted by miriam
15 videos for repairing Singer 301
Originally Posted by Bennett
Okay, I didn't think it was really that intuitive and the manual wasn't that easy for me to understand, but I figured it out. I used some yarn so the points would be more visible (It didn't fit, but I hope you get the idea).
1. Bring the thread from the spool to the guide at the top. There were several types. The small disks may be flat or upright, or it may just be a guide without the disks.
2. Bring the thread down to the slot at the bottom of the tension mechanism.
Originally Posted by amazon
I made this with the fall collection from Walmart and a little stash. I posted recently about one I made for our pastor for Pastor Appreciation Day. It was made from his fathers clothing. I didn't want to leave out our Pastors wife, so this is her lap quilt . She will recieve it today at church since I had operator error last week and was unable to finish.(Remember the needle and door post,lol) I gave her a pic. and an IOU for this week. She was very gracious. I used bamboo batting also, it has