Two tips to threading your machine
#13
Senior Member
Join Date: Nov 2010
Location: NE SDakota
Posts: 473
Presser foot UP! Needle UP! As long as there was no thread in her machine, it didn't matter if she turned the knob forwards or back, she was just showing that the thread take-up needs to be at its highest point. Otherwise, when you start to sew, as soon as that take-up lever goes UP, it will pull your thread right out of the needle. And then you can start over again.
#14
I meant Presser foot UP, which is why I went on to say I had been putting it down. It might take me a while to remember to put it up though.
I've had the thread come out by turning the wheel. I bought a new lightweight Brother to take to class and I have to actually hold the thread and line up the hand wheel each time I stop stitching or it will do that. It will also create a big mess from attempting to get to the right position to start the first stitch. I couldn't figure out what was wrong with it till I read the manual -- imagine that? You're supposed to read the manual?? There is a raised plastic line on the hand-wheel where it should be lined up and I darkened it with a permanent Sharpie.
It's a real pain to remember since I learned to sew on my Janome which returns itself to the right position.
I've had the thread come out by turning the wheel. I bought a new lightweight Brother to take to class and I have to actually hold the thread and line up the hand wheel each time I stop stitching or it will do that. It will also create a big mess from attempting to get to the right position to start the first stitch. I couldn't figure out what was wrong with it till I read the manual -- imagine that? You're supposed to read the manual?? There is a raised plastic line on the hand-wheel where it should be lined up and I darkened it with a permanent Sharpie.
It's a real pain to remember since I learned to sew on my Janome which returns itself to the right position.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
5
04-25-2011 10:47 AM
craftybear
Links and Resources
1
02-21-2011 08:29 PM
craftybear
Links and Resources
5
09-23-2010 11:57 AM