Adjusting a new longarm
#1
Is there a formula for how high a longarm machine should be and the correct angle for the handlebars? My husband keeps wanting to adjust it and I told him I would ask ya'll if there is a way to know.
#2
Power Poster
Join Date: Feb 2009
Location: Northern Michigan
Posts: 12,861
it should be adjusted for your height, what is comfortable for you when you are using it...hands, elbows, shoulders need to be in a natural position or you will be aching and having a hard time quickly, it has to be the right height/angle for you personally
#3
Super Member
Join Date: Feb 2010
Location: Fort Worth, Texas
Posts: 3,291
As ckcowl said, it has to be comfortable for you. And, that may take a few times adjusting until you get the right feel. You may think it feels good and after working with it for a little bit, you might have to adjust it again.
#4
These answers are exactly correct. When my HQ18 Avante arrived and the guy put it together, he had me come stand near it and put my hands on the machine. He asked if that was comfortable and if I wanted it higher or lower. The proper height is one that is not straining to YOU. I find that I end up feeling back pain after pinning (so considering a zipper or red snappers), but running the machine it's the perfect height. Adjust it with you standing as if you would be running the machine.
#5
I purchased a hydraulic lift so when I'm working at the back of the machine, the handles will be at an elevated height. When I working at the front of the machine, I lower the table. Your elbows should be at a right angle for long term use comfort.
#6
Originally Posted by quilttiludrop
I purchased a hydraulic lift so when I'm working at the back of the machine, the handles will be at an elevated height. When I working at the front of the machine, I lower the table. Your elbows should be at a right angle for long term use comfort.
Thread
Thread Starter
Forum
Replies
Last Post
heart of Dixie
For Vintage & Antique Machine Enthusiasts
7
01-06-2013 03:19 PM
annesthreads
For Vintage & Antique Machine Enthusiasts
14
01-15-2012 09:36 AM