Embroidery help, please!!!
#1
Embroidery help, please!!!
What an afternoon!I was trying to embroider some Christmas towels. Everything was going well until the thread got wrapped around the spool holder & jammed everything. After I fixed that it seemed like one thing after another went wrong. I fixed the bent needle, I fixed the jammed thread in the bobbin, I scrapped the towel & that design & started freash on a hand towel only to find the bobbin thread is showing on the design and NOT the top thread. Maybe I am just brain dead but I can't remember what I need to do to adjust that. I have a Bernina QE 440 with the module. What the heck did I do now?
#3
Can you see the top thread at all? If you can, you just need to adjust the tension. You might want to just turn off the machine and turn it back on, like you have do with computer when is gets of kilter.
#4
thanks! Yes, I replaced the needle. The top thread barely shows at all. I did turn her off...and walk away....far away! I'll try again tomorrow. I adjusted the top tenion some but didn't want to go to far with it.
#8
Thread
Thread Starter
Forum
Replies
Last Post
CIGAINEROJD
Main
0
02-26-2011 09:39 AM
craftybear
General Chit-Chat (non-quilting talk)
1
01-15-2011 04:13 AM