my experience with Folded Corner Unit
10-05-2012, 12:00 PM
#21
Power Poster
Join Date: Dec 2010
Location: Northern California mountains
Posts: 12,538
Very nice work.
My experience was that I needed to be 1 seam width over from the center. I used an iron and very lightly pressed the diagonal, so as not to have a mark that might show. Otherwise, your pieces are a seam width to small. If you are doing this or snowball or any other folded corner unit, do one and check before you go on.
My experience was that I needed to be 1 seam width over from the center. I used an iron and very lightly pressed the diagonal, so as not to have a mark that might show. Otherwise, your pieces are a seam width to small. If you are doing this or snowball or any other folded corner unit, do one and check before you go on.
Thread
Thread Starter
Forum
Replies
Last Post
cmw0829
Main
55
02-27-2012 06:59 PM
