I used my design wall as an ironing surface.
#1
I used my design wall as an ironing surface.
I dread working with backing. It's big, it's hard to wrangle on a ironing table much less a regular ironing board. It gets all wrinkled up about as fast as I can iron it. I had this big 108" wide backing fabric and it was full of folds and wrinkles. I pinned it to my design wall and had it ironed in about 5 min. I will spray baste the batting and quilt top on it and then fold and move it up to get the lower section ironed. The ironing is keeping the fabric snug on the wall, it is clinging very tight. [ATTACH=CONFIG]362950[/ATTACH]
#3
The best discovery I've made lately is that I can take all the wrinkles out of quilt backing on the longarm. Just load the backing, stretch the first section, mist finely with water, and the wrinkles disappear like magic. Roll to the next section, repeat, voila! And no ironing. I do usually let each section dry before rolling to the next section.
#6
Super Member
Join Date: Aug 2010
Location: Piedmont Virginia in the Foothills of the Blue Ridge Mtns.
Posts: 8,562
What is your design wall made of? What is under the batting/flannel? I'm wondering if mine of foam insulation board would melt if used like this.
Jan in VA
Jan in VA
#7
It is the foam insulation with the silver backing I bought at Lowe's and it's covered in felt. No problem with the heat. I figured it was insulation so it would insulate. I didn't use steam but I did spray starch the backing a little.
#8
Super Member
Join Date: Aug 2010
Location: Piedmont Virginia in the Foothills of the Blue Ridge Mtns.
Posts: 8,562
A recent finished commission was the first time I've heavily starched the backing and top -- ala Sharon Schamber -- and I'm not sure that I noticed a whole lot of difference from the way I've done lot for years. I still have a new can of starch, so I'll try it again at some point.
Jan in VA
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
0
01-20-2011 10:26 PM
craftybear
Links and Resources
14
11-28-2010 09:07 AM