Olfa rotating cutting mat
12-05-2011, 07:09 PM
#1
Junior Member
Thread Starter
Join Date: Jan 2011
Location: Alabama
Posts: 202
Olfa rotating cutting mat
Today I purchased a 17X17 Olfa rotating mat at Joanns. Was 50% off plus I had a 20% coupon. Yay!
But....I am a little disappointed. I guess I was expecting it to turn easily, and it doesn't. Does anyone know if it gets easier to turn with use? Thanks!
But....I am a little disappointed. I guess I was expecting it to turn easily, and it doesn't. Does anyone know if it gets easier to turn with use? Thanks!
12-05-2011, 07:20 PM
#3
Super Member
Join Date: Jan 2010
Location: Yakima, WA
Posts: 2,439
It should turn easy, I have two of them, I turn them by placing my fingers on the corner and turning, not at the center. It is also very helpful if you put a non skid pad under them. I use the rubberized kitchen liner you can get at the dollar store. If it moves at all on your table, it will be difficult to turn. The liner stabilizes it.
12-05-2011, 07:59 PM
#5
Super Member
Join Date: Jun 2011
Location: Michigan. . .FINALLY!!!!
Posts: 6,726
Originally Posted by Holice
I had the same problem and discovered I had not taken it out of the bottom base piece then it rotated.
12-06-2011, 02:07 AM
#8
Super Member
Join Date: Dec 2010
Location: MO (the Show Me state)
Posts: 2,947
i know during the black friday sale, that mat was 60% off. i tried to order it online but it was temporary out. after the sale was over they magically had more. i will wait to see if the mats go on 60% sale closer to ch
ristmas.
ristmas.
Originally Posted by sewbeadit
How do you all get a 60% off coupon for JoAnns. Here it is only 40% most all the time.
12-06-2011, 04:27 AM
#10
Super Member
Join Date: Aug 2010
Location: Australia
Posts: 4,116
I had not seen the square mat before I bought the circular one which is on the right in the top row of the link at the bottom. I got it for $47 at a craft show. However, judging from the prices on the other mats there would have been no sale if I'd seen the others first. The only problem with the completely circular one is that it has a tendency to swing a bit too easily and as it is raised about 2cm off the table it is difficult to cut and rotate pieces that are larger than about 12".So it is really best for small, fussy cutting. Hope this advice is helpful to folk in my neck of the woods.
http://www.victoriantextiles.com.au/...y:Cutting+Mats
http://www.victoriantextiles.com.au/...y:Cutting+Mats
Thread
Thread Starter
Forum
Replies
Last Post
