JanetLinda

Hello,

I would like to change the foot pedal control that is supplied with the machine for a hand held such as that made by The Grace Company, however, the connection to the machine is a vga type.
Does anyone have experience of this conversion?

AZ Jane

I would contact Pfaff and / or the Grace Company first. I know very little about electricity but always asked my father who was a Journeyman Electrician. I always started at the top! LOL

ELIZABETHCOOK

this is a long shot because this is an old post but I am seeking to do the same thing with my power quilter did you figure it out?

ssandvik

My power quilter error message says no foot pedal. So because it does not recognize it I can’t do anything. Has someone else had this problem? Is it just the foot pedal ( which was new last July) or the pin connector for the foot on the machine?
when I turn the machine on it runs on its on with the error message and quickly gets up to high speed so I have to shut it off.
many ideas or suggest would be helpful.