unraveling thread
#2
Are you talking handquilting?/ appliquing?
Just tie off at that point, put the needle into the fabric in your stopping place, with it still threaded ...
Do you know how to end off at the end of your applique project?
You can do that anywhere along the way ... a couple of backstitches under the applique will do the same thing.
Just tie off at that point, put the needle into the fabric in your stopping place, with it still threaded ...
Do you know how to end off at the end of your applique project?
You can do that anywhere along the way ... a couple of backstitches under the applique will do the same thing.
#3
Senior Member
Thread Starter
Join Date: Jul 2008
Location: Arcadia, Ca.
Posts: 397
I guess I wasn't clear in what I was asking. I was referring to the thread coming off the spool. When I carry my thread in my bag the threads keeps coming off the spools and getting all tangled.
Janie
Janie
#4
WHen you start the thread, isn't it put into a little notch at the top of the spool?
Sometimes, we lose that slit ... tip: put fingernail polish next to the slit so you won't lose it.
You can put a half hitch on the spool with the thread, which is how the thread I get from connecting thread arrives.
Now, how to tell you how to do a half hitch: deep breath ...
I am left-handed, so if anything I tell you is awkward, just do what I say with your right hand and it will work out just fine. so!
set the spool on your desk (I am assuming you are sitting at the computer) .... have some thread, maybe six inches laying off to the side of the spool ...
pick up the thread in about the middle of the length and do a little twist to create a loop .... move the loop toward your spool, and slip it over the spool, snug the loop on the spool by pulling on the loose end ...
if I can find a link, I will post it for you.
YOu can also buy some netting and cut it to size (height), slip the spool inside.
Sometimes, we lose that slit ... tip: put fingernail polish next to the slit so you won't lose it.
You can put a half hitch on the spool with the thread, which is how the thread I get from connecting thread arrives.
Now, how to tell you how to do a half hitch: deep breath ...
I am left-handed, so if anything I tell you is awkward, just do what I say with your right hand and it will work out just fine. so!
set the spool on your desk (I am assuming you are sitting at the computer) .... have some thread, maybe six inches laying off to the side of the spool ...
pick up the thread in about the middle of the length and do a little twist to create a loop .... move the loop toward your spool, and slip it over the spool, snug the loop on the spool by pulling on the loose end ...
if I can find a link, I will post it for you.
YOu can also buy some netting and cut it to size (height), slip the spool inside.
#6
#8
I use the plastic webby grid stuff sold to hold thread in place. It comes in a long tube and you cut off the size you need. Also one of the fuzzy pony tail bands will keep the thread from unraveling and will not cut into the thread.
Thread
Thread Starter
Forum
Replies
Last Post