Help with Clover Bias Maker
Hello Friends hope you can help. I purchased two Clover Bias Maker some time ago and thru away the package. Now when I look to find out what size to cut the strips all Clover site tells me is to follow the dimensions on the package UHHHGGGHH Does anyone out there have a chart for the these???? Anything that will keep me from wasting a ton of material on trial and error???? PLEASE
|
what size are your bias makers? each size needs it's own size strips---as in for 1/4" you need to cut your strips 3/4" wide. in order to help you know your sizes we need to know what size maker you are using.
|
oh thank you the clover maker i am using has a finish width of 5/16 and insert width of 1in does that help
|
Oh it has an 18 on the bottom side
|
How did you get the insert width of 1 inch? I went to check mine and realized that it also is out of the packaging! If you think about it, though, these make double-fold bias tape. I would cut a one-inch strip of fabric and see how that works out; should be about right for ending up with a 5/8-inch wide strip. (Theoretically you could cut a strip up to 1-1/4 inches wide, but I think then you would risk overlap of the ends.) If one-inch is a little too small, I would try 1-1/8" wide strips.
|
Does this help if you use the drop down used for ordering it will tell you the size . I beleive its the finished size and you would have to add 1/2 inch for 1/4 inch turn under on each side. I have the #18 ( the red) for finished 3/4 inch but use fabric cut 1 &1/2 inch.
http://www.clover-usa.com/product/26...as_Tape_Makers |
Thank you I knew I could count on my quilting friends for help. I do have the #18 Red and you measurements were on spot. Thanks again.
|
I don't have mine in front of me right now but I think the strip size is stamped on each "form" or maker or whatever it's called.
|
All times are GMT -8. The time now is 09:05 AM. |