Rail fence with pinwheel question.
#1
Junior Member
Thread Starter
Join Date: Jan 2011
Location: St. Augustine, Fl and Nashville, Ga.
Posts: 267
Rail fence with pinwheel question.
Hi, I wanting to make the rail fence with pin wheel quilt. My pattern is for the rails to be 2 1\2 inches. This will be a scrappy quilt and I need the rails to be 2" (already have these in stash). My question is what size to cut the half square triangles? Thanks for your help. Pat
#3
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
Seems to me that the pinwheel portion is 2 rails wide? Is that right?
Each 2" rail will finish at 1.5", so each HST patch of the pinwheel will finish at 1.5" (the entire pinwheel will be 3" finished) So you add 7/8" to the finished size of 1.5", which comes to 2 3/8". Since we want a little wiggle room, round up to 2.5", sew your HST and trim.
Make a sample to double check!
Each 2" rail will finish at 1.5", so each HST patch of the pinwheel will finish at 1.5" (the entire pinwheel will be 3" finished) So you add 7/8" to the finished size of 1.5", which comes to 2 3/8". Since we want a little wiggle room, round up to 2.5", sew your HST and trim.
Make a sample to double check!
#5
If your rails are 2-1/2" cut, 2" finished, then use 2-1/2" cut squares and sew them to the rail, through the center of the square. Similarly, 2" cut rails finishing at 1-1/2" would use 2" cut squares.
I wouldn't bother with doing HST's here, It will make you nutty.
I wouldn't bother with doing HST's here, It will make you nutty.
#7
#8
Here are free patterns for two versions: http://colormequilted.com/favorite-patterns/
#9
Thread
Thread Starter
Forum
Replies
Last Post