Rulers for cutting scraps?
#12
Super Member
Join Date: Dec 2010
Location: Chula Vista CA
Posts: 7,340
My go-to rulers 6.5 x 24, 6.5 x 12, 3 x 18, and the 1 x 6. For marking the 1/4 inch I have a 6 inch long 1/4 inch square ruler.
I have a lot of squares starting at 3 inches going up to 15 inch. I would buy them as a I felt a need for them or as I would find them on sale. Just can't seem to pass a 50 to 60% off.
I have a lot of squares starting at 3 inches going up to 15 inch. I would buy them as a I felt a need for them or as I would find them on sale. Just can't seem to pass a 50 to 60% off.
#14
Super Member
Join Date: Oct 2010
Location: Nebraska
Posts: 3,252
I have a 6.5 inch square Omnigrid and I like that size for small pieces. But recently after reading a recommendation on here about Creative Grids, I bought the 12.5 square to try out since I needed to replace my original one. I love it! It is easy to read and doesn't slip around at all. So I am in the process of swapping out all of my Omnigrids for Creative Grids. Found the 6.5 x 24 on sale, locally, yesterday. For you, I would recommend CG 6.5 square for sure.
#15
Super Member
Join Date: Mar 2011
Location: Central NJ
Posts: 5,570
I'll just go with my standard mantra since I don't do scraps. Find a brand of ruler and purchase that brand when getting new sizes. Not all rulers are created equal. Some have thicker/thinner lines; more/fewer measurements; etc. I have found that when using different brand rulers within a project, I have issues. Usually small and manageable, but issues nonetheless. One of these days I'll figure out which brand I like best and I need to add/replace will practice what I preach.
#16
Senior Member
Join Date: May 2011
Location: Waynesboro, Tn.
Posts: 932
#18
Super Member
Join Date: Jun 2010
Location: The Deep South near Cajun Country, USA
Posts: 5,383
I like a lot of my rulers. For squaring up, I use the 6.5" and 12.5" more than the others I have. The 4.5" is just too small for me. I can't seem to keep it straight. It slips badly. If I am cutting strips, I have a 6x18, 6x12 and a 3x24 that I use. I like rulers! And I have a lot of specialty rulers that I almost never use, but every once in a while I will go looking for them.
Thread
Thread Starter
Forum
Replies
Last Post
leatheflea
Pictures
8
08-25-2011 06:36 PM
craftybear
Links and Resources
4
07-27-2011 07:29 PM