scant 1/4 inch seam
06-25-2009, 08:05 AM
#3
Moderator
Join Date: Jan 2007
Location: In the middle of a mess...
Posts: 20,025
I can't move the needle on my 1/4 inch foot. If I do, I'll break the needle. My foot only has a little area for the needle to sew in. If I used another foot, I'm sure I could get it to measure 1/4 inch, but I'm too lazy to do that.
06-25-2009, 08:25 AM
#5
Power Poster
Join Date: Jul 2007
Location: Out searching for some sunshine :-)
Posts: 58,856
I can't move the needle on mine either without the needle hitting. I was thinking about enlarging the needle hole in mine just large enough to move the needle over one click. (Mine is clear plastic) I was wondering if a small dremmel (sp) tool would work for this??? Another thought was to take the foot to a glass shop and have them drill it out a little bigger.
06-25-2009, 08:37 AM
#7
Power Poster
Thread Starter
Join Date: May 2008
Location: MN
Posts: 24,391
I just don't care the the "scant 1/4 inch" instruction. It annoys me.
I've finally learned to cut my squares for the HST's 1 inch bigger than I want finished, use my REGULAR 1/4 inch seam, and trim later, if needed.
And yes, I know, there seem to be as many ways to do HST's as there are quilters.
I've finally learned to cut my squares for the HST's 1 inch bigger than I want finished, use my REGULAR 1/4 inch seam, and trim later, if needed.
And yes, I know, there seem to be as many ways to do HST's as there are quilters.
06-25-2009, 10:20 AM
#9
Power Poster
Join Date: Jan 2009
Location: Front row
Posts: 14,646
This may sound odd but this works great for me. I have a machine foot that is less then 1/4" and more than a scant 1/4" it's about 3/16". I use that for my seams. I have better luck with the pieces being the right size if I sew the seams smaller then 1/4". If I try for the 1/4" it never fails I end up with a block that is smaller then it should be. I seldom have to trim sewing the 3/16" seam. I use a short stitch length to compensate for the smaller seam.
06-25-2009, 12:48 PM
#10
Banned
Join Date: Apr 2009
Location: Sleepy Hollow, NY
Posts: 4,727
i'm confused why do you need a 1/4 foot when sewing HST?
don't you use a large square, sew 2 lines down the middle and cut apart.
i've never used by 1/4 foot for HST i use my clear open toe foot and i can make my seam scant or exactly 1/4 - its whatever i choose it to be.
don't you use a large square, sew 2 lines down the middle and cut apart.
i've never used by 1/4 foot for HST i use my clear open toe foot and i can make my seam scant or exactly 1/4 - its whatever i choose it to be.
Thread
Thread Starter
Forum
Replies
Last Post
