Need idea
#21
Member
Join Date: Jul 2012
Location: Lawrenceville, GA
Posts: 30
I have 2 of those cutting tables think came from hancocks million years ago u know it rolls and ends lift up to make cutting area or fold down to save space. Well my problem with height is different. Most need something to make cutting tables higher i am only. 5 ft. Seem to be shrinking as I age too!! So these cutting tables are a tad too high to be really comfortable. So do I scrap them or is there something. I can do to make these more comfortable? I am getting ready to empty my sewing room paint walls a creamy yellow and all the furniture some color so it all blends together better. This was my mil sewing room it's been 2 years she's been gone so am ready to make it mine. Figured smart as people on this board are someone could tell me about the cutting tables! Thanks!
#23
Have someone cut off the legs to a more comfortable height and then put the rollers back on. My DH put the wheels on a huge cabinet so we can roll the TV out from the wall when we wanted to watch it. It is not a hard job at all.
#24
Good to hear from othe 'altitude challenged' ladies. Last time measured, I dropped below 5'! Am considering cutting legs of sewing tables that I inherited from DM(5'6"). Rollers or gliders will be my solution.
#25
I would hate for you to loose the movability too. Do you know anyone who can make a 2' x 4' platform out of 2 by 6's.
That would give you 6" of height and make it so you can slide it under the table when not using it. Or even make it as long as the table is when it is extended.
My problem is just the opposite. I am 5'9" and end up with a back ache when I use anything to cut my fabric, etc
Good Luck
That would give you 6" of height and make it so you can slide it under the table when not using it. Or even make it as long as the table is when it is extended.
My problem is just the opposite. I am 5'9" and end up with a back ache when I use anything to cut my fabric, etc
Good Luck
#27
I am 5' and it hurts my shoulders if I have to stand at that table very long. I took the wheels off, have small moving men under the legs (of course my table doesn't get moved very often). It works so much better. What made me think of that was I removed the wheels on both my sewing cabinets, much easier to set and sew. My chair was up as high as it wud go so had to think of something. It works for this shorty.. ;o)
I have 2 of those cutting tables think came from hancocks million years ago u know it rolls and ends lift up to make cutting area or fold down to save space. Well my problem with height is different. Most need something to make cutting tables higher i am only. 5 ft. Seem to be shrinking as I age too!! So these cutting tables are a tad too high to be really comfortable. So do I scrap them or is there something. I can do to make these more comfortable? I am getting ready to empty my sewing room paint walls a creamy yellow and all the furniture some color so it all blends together better. This was my mil sewing room it's been 2 years she's been gone so am ready to make it mine. Figured smart as people on this board are someone could tell me about the cutting tables! Thanks!
#29
After taking the wheels off, if it's still a little too high, you could go to Home Depot or Lowe's and buy a couple of those rubber mats to stand on. That will make standing at your cutting table more comfortable, and it will raise YOU up a couple inches.
Thread
Thread Starter
Forum
Replies
Last Post