Jenniky

QAYG HOLIDAY Reversible TABLE TOPPER

Rate this Entry
by , 09-05-2012 at 03:22 PM (470 Views)
Quote Originally Posted by Jenniky View Post
Name:  SeptQFR 012.JPG
Views: 1366
Size:  166.8 KB

Once I am sure my sashing lines up accurately. I then measured the width from the edge of one seam of batting to the opposite.
In this case it turned out to be an even 4 inches.

Name:  SeptQFR 013.JPG
Views: 1347
Size:  107.5 KB

I cut a 4 x 9 1/4 piece of batting giving my self a little more than necessary on the length to be trimmed later.

Name:  SeptQFR 014.JPG
Views: 1348
Size:  110.3 KB

Laying the batting in the sashing canal. I make sure there is no bunching of the batting. It needs to lay nicely in as if it were a puzzle piece.

Name:  SeptQFR 015.JPG
Views: 60
Size:  97.6 KB

I then take large basting stitches down both sides to hold the batting from sliding.

Name:  SeptQFR 016.JPG
Views: 56
Size:  97.6 KB Name:  SeptQFR 017.JPG
Views: 60
Size:  104.7 KB

Now I place a very thin line of glue on the edge of my material to hold my flap in place.

I seem to have not taken a picture sewing the seam. I used my open foot so that I could clearly see where
I was sewing and I sewed from the front down the ditch line.

Name:  SeptQFR 018.JPG
Views: 60
Size:  142.6 KB

When I turned it over I had a perfect machine seam.. Ah Ha... I must of done it right.

More Steps to follow in the next post.
Tags: None Add / Edit Tags
Categories
Uncategorized

Comments


SEO by vBSEO ©2011, Crawlability, Inc.