Quiltingboard Forums

Quiltingboard Forums (https://www.quiltingboard.com/)
-   Main (https://www.quiltingboard.com/main-f1/)
-   -   Pin basting question (https://www.quiltingboard.com/main-f1/pin-basting-question-t274783.html)

ruby2shoes 01-21-2016 01:40 AM

Pin basting question
 
I pin baste my work, using a large table and bull dog clips to hold the layers to the table edge. Usually I baste my quilt in one session, setting aside an afternoon to do it. Can there be any reason why I couldn't clip my layers out on the table and start to pin baste and then leave it for a day or two before continuing? Must it all be done in one "session"?

quiltsRfun 01-21-2016 03:28 AM

I don't see any reason why it needs to be done in one session. However, I'm no expert at pin basting. I've only done a couple with pins. I now spray baste.

NJ Quilter 01-21-2016 04:13 AM

I use the same process as you. Seems to me I've left mine overnight or longer while in the midst of pinning. Particularly the monster king/queen sizes. No reason not to leave it. Have to do a bit more smoothing when re-positioning but I do that anyhow.

ranger 01-21-2016 04:36 AM

I baste same as you do, with pins and clamps.
I have left mine overnight (about 17 hours) with no difference seen.

QltrSue 01-21-2016 04:54 AM

As I see it, there should be no problem with leaving it for a short time--overnight or so. I would try to support the overhang if it was very large and heavy to prevent stretching or distortion. JMHO.

ManiacQuilter2 01-21-2016 06:00 AM

Usually I just use the bull clips to hold the bottom smooth, then lay out the batting making sure it is smooth and then lay the quilt top down. I have left a quilt just as is and came back to finish pinning the next day with no worries but I don't have a cat in the house. Why not just pin the outside edges and then you could reposition the bull clips to hold everything in place.

ruby2shoes 01-21-2016 11:09 AM

Thanks everyone. Appreciated.

janecat 01-21-2016 03:33 PM

What size bull clips do you use?

Do you get them at an office supply store or some place like Home Depot or on Amazon?

osewme 01-21-2016 04:20 PM

I don't see a problem with leaving it for overnight. I think I've done that before & don't remember it being an issue. The next time I pin baste I'm going to try it by leaving the pins open. I can't remember if I read that on this board or on a blog somewhere but it sounded good to me. I also read that one quilter left her pins in while she did stippling & just stippled around her pins. That way she didn't have to take them out during the quilting process & it saved a lot of time. These are a couple of things I want to try in the future.

ruby2shoes 01-22-2016 12:39 PM

Hi Janecat......I don't know what size bulldog clips I use, just got a box of some big ones from the local Office supply chain over here. Works well.


All times are GMT -8. The time now is 03:10 PM.