Thanks. Some of the points are off and even after increasing the print size, measuring, and re-measuring, the block is too small. So, back to the drawing board.
I guess the easiest thing to do, is print out the pattern at actual size. Then place on your scanner and find your Enlarge button. On mine, when I find <100%>, I hit OK and then use the less than < button to decrease or the greater than > button to increase your size by about 30%. Print, cut out, place together, measure. If not correct, start over going up or downwith your buttons. It isn't as bad or hard as it sounds. Just don't forget to add you 1/4" seam allowances.