Finished result

[ATTACH=CONFIG]279504[/ATTACH]

Start with wedges. These are 9 Degree, but any will work

[ATTACH=CONFIG]279505[/ATTACH]

Fold the top in half and sew across.

[ATTACH=CONFIG]279506[/ATTACH]

Turn them inside out and iron. Make sure the seam is in the middle.

[ATTACH=CONFIG]279507[/ATTACH]

I opened my seams inside of the point.

[ATTACH=CONFIG]279508[/ATTACH]

Obviously wrong for example only.

[ATTACH=CONFIG]279509[/ATTACH]

Sew together matching the points.

[ATTACH=CONFIG]279512[/ATTACH]

Sew the pairs into foursies. I open my seams.

[ATTACH=CONFIG]279513[/ATTACH]

Finally fours in to eights. There ate two fans here.

[ATTACH=CONFIG]279516[/ATTACH]

Then I used my circle cutter to determine the circle I needed was 8 inches. then cut the circle into fourths.

[ATTACH=CONFIG]279518[/ATTACH]

You can do your curved seam in one of two ways. This is easeing it in.

[ATTACH=CONFIG]279520[/ATTACH]

Resulting in this.

[ATTACH=CONFIG]279522[/ATTACH]

OR... you can face your 1/4 circle with a light fabric and turn it.

[ATTACH=CONFIG]279523[/ATTACH]

Sewing the 1/4 circle to the facing.

[ATTACH=CONFIG]279524[/ATTACH]

Clip the curve and turn.

[ATTACH=CONFIG]279525[/ATTACH]

Top stitch the 1/4 circle to the bottom of the fan.

[ATTACH=CONFIG]279526[/ATTACH]

Resulting in this.

[ATTACH=CONFIG]279527[/ATTACH]

Cut your back and batting. I turned the curved edge of the back over the top of the batting then pinned it to the fan just below the valleys of the points.

[ATTACH=CONFIG]279528[/ATTACH]

Here you can see the points above the backing and batting.

[ATTACH=CONFIG]279529[/ATTACH]

Choose your quilting pattern and quilt as desired.

[ATTACH=CONFIG]279533[/ATTACH]

The point side is finished and you only have to bind the two straight sides turning the ends under on the points. Enjoy!!!

[ATTACH=CONFIG]279538[/ATTACH]