Originally Posted by
angelanicole
I don't have any tips just a question. Can you dilute the Elmers glue with water or something else and spray it
on the layers? Did anybody do an experiment with this? I would not mind to have suggestions and try it out.
Ty for your response. This board is marvelous for new tips and tricks of the trade.
I prefer to dilute the glue and use a paint brush. When you spray you can't really tell
which part you missed and if you overspray then it becomes too wet plus you have
to dilute the glue a lot more to go through a spray without clogging.
Another reason I like to dilute the glue is to avoid those hard spots where the needle
can break. A little goes a long way with Elmer's.