Help! 1967 Sears Kenmore machine.
11-01-2012, 02:53 PM
#1
Member
Thread Starter
Join Date: Oct 2012
Location: Southern Illinois
Posts: 32
Help! 1967 Sears Kenmore machine.
Hello Quilting Friends,
Awhile back, I received this machine as a gift from some friends who's aunt had moved away. The machine is in beautiful condition but it doesn't have a belt on the back, and when i use the foot pedal there is a burning smell. Does anyone have any advice on what I should do or where I could get a new belt?
Thanks for your help!
Jamie C.
Awhile back, I received this machine as a gift from some friends who's aunt had moved away. The machine is in beautiful condition but it doesn't have a belt on the back, and when i use the foot pedal there is a burning smell. Does anyone have any advice on what I should do or where I could get a new belt?
Thanks for your help!
Jamie C.
11-01-2012, 04:53 PM
#3
Power Poster
Join Date: Mar 2009
Location: Lake Elsinore, CA
Posts: 15,163
If it smells like something is burning don't use it - take it to someone for repair. It could just be a capacitor that needs to be replaced, or it could be that the wiring is old and breaking down. Don't leave it plugged in, just in case.
11-02-2012, 06:09 AM
#5
Super Member
Join Date: Feb 2012
Posts: 8,091
Jamie,
Since this is a cabinet machine it lays on it's front side when in storage. The motor is right on top in the path of dust, lint, particulates and even pet hair. All this and old oil will collect inside the vent holes of the motor and will burn off when you start using it. Even portables do this, but to a lesser extent.
Do a visual check on the wiring from where it enters the motor to the plugs, to the foot controller, and under the machines body. If it looks good, oil the motor then run it wide open for a while. You'll hear it change pitch as it cleans out the dirt and debris. (These instructions came from my LSMG)
Belts can be had at your LSMG or Sew Classics as well as other places.
Joe
Since this is a cabinet machine it lays on it's front side when in storage. The motor is right on top in the path of dust, lint, particulates and even pet hair. All this and old oil will collect inside the vent holes of the motor and will burn off when you start using it. Even portables do this, but to a lesser extent.
Do a visual check on the wiring from where it enters the motor to the plugs, to the foot controller, and under the machines body. If it looks good, oil the motor then run it wide open for a while. You'll hear it change pitch as it cleans out the dirt and debris. (These instructions came from my LSMG)
Belts can be had at your LSMG or Sew Classics as well as other places.
Joe
11-02-2012, 06:24 AM
#6
Senior Member
Join Date: Jun 2012
Location: Minnesota, USA
Posts: 396
I was going to say what Joe said...lint and dust. In the meantime, you can unplug it and clean and oil it before trying it again. Use the hand wheel to move all the joints. I think I have this same machine, or one very similar. What is the model?
11-03-2012, 05:06 AM
#8
Super Member
Join Date: Feb 2012
Posts: 8,091
Joe
Thread
Thread Starter
Forum
Replies
Last Post
SteveH
For Vintage & Antique Machine Enthusiasts
23
08-27-2015 05:14 PM
liking quilting
For Vintage & Antique Machine Enthusiasts
4
11-09-2012 06:35 PM
