Janome foot pedal stops?
#1
Janome foot pedal stops?
I have a Janome 8050 and while piecing tonight and last night my foot pedal kept beeping and looked like it wasn't getting power. It would stop working and the picture of the foot pedal would dissapear from my display. Is it just a short in the foot pedal? I'll call Janome tomorrow but I was wondering if this has happened to anyone else.
#4
Do you have a sew machine dealer close by? Mine was doing that too, and I had to press on the foot pedal a couple of times to get it to sew; or it would keep sewing after I took my foot off . I had taken my pedal to the dealer about a year ago and he took it apart and cleaned it. but it has been doing it again ; so I took it back and he sold me a new one. He said they sometimes wear out after a lot of use; the soldering breaks.
#5
Super Member
Join Date: May 2011
Location: Folsom, CA
Posts: 1,548
I had a Janome foot pedal that stopped and then sometimes raced and I had to turn off the machine to get it to stop. Very scary. I took it to the dealer and they had me purchase another pedal that looked the same. Sure enough a few months later the same thing happened again. I think it was a defective pedal = the one I have now has a retractable cord and is a different design. It does not do that. If your is a narrow foot pedal that does not have a retractable cord, it is probably like my old one. Not good, especially when it races at full speed. My retractable cord foot pedal has been wonderful.
#7
I took her into the shop and they said it's probably the plug acting up. I had to leave her there for a few days and I'm so sad without her! Lol
I looked at the large harp machines there and might be convincing hubby to get me the élan 730. Looks so nice and they will give me $300 for trade for my machine. I hope he lets me get it I'm crossing my fkngers
I looked at the large harp machines there and might be convincing hubby to get me the élan 730. Looks so nice and they will give me $300 for trade for my machine. I hope he lets me get it I'm crossing my fkngers
Thread
Thread Starter
Forum
Replies
Last Post
joobee
For Vintage & Antique Machine Enthusiasts
9
04-07-2014 06:04 AM
Treasureit
Links and Resources
56
07-21-2013 07:33 AM