'Stored' machines, oiling or not, how often to run?
08-31-2015, 11:43 AM
#11
Junior Member
Join Date: Apr 2014
Posts: 200
08-31-2015, 12:01 PM
#12
Banned
Join Date: Oct 2012
Location: San Lorenzo, CA
Posts: 5,361
I would consider carefully whether you want to use a piece of fabric under the presser foot. Fabric can act as a moisture collector. I have purchased more than one OLD machine with fabric under the presser foot that the fabric was bonded by rust to the needle plate. I also find needles that were left in fabric where the contact points are rusty, so again. I would not recommend the fabric under the foot (or wrapped around the machine for the same reason)
08-31-2015, 06:19 PM
#13
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
I frequently find old machines that have been 'stored' The worst ones are the machines that are clean and no oil. No oil can lead to rust. I would rather clean off old dried oil than rust. Just my 2 cents
09-01-2015, 12:17 PM
#14
Junior Member
Join Date: Apr 2014
Posts: 200
I would consider carefully whether you want to use a piece of fabric under the presser foot. Fabric can act as a moisture collector. I have purchased more than one OLD machine with fabric under the presser foot that the fabric was bonded by rust to the needle plate. I also find needles that were left in fabric where the contact points are rusty, so again. I would not recommend the fabric under the foot (or wrapped around the machine for the same reason)
Place Your Machine In Storage If possible store your machine in a temperature controlled environment. Outside storage in a shed or garage is unacceptable. Extreme temperature changes will produce condensation, which will rust your machine. The ideal storage area would be in a closet inside your home. Place your machine where nothing will fall on it or bump into it.
09-01-2015, 01:17 PM
#15
Banned
Join Date: Oct 2012
Location: San Lorenzo, CA
Posts: 5,361
ok, not trying to get into a argument here, and I agree that indoors is the way to store a machine, but there is moisture in the air at all times. Homes are sometimes even worse than outdoors with central heat and air etc.
Most of the machine I referenced that had rusted fabric were stored indoors.
You have the freedom to do as you will, but I am trying to give advice to folks who may not have all of the knowledge and or experience to make a call like that. Not everyone has dealt with a couple hundred antique sewing machines.
Most of the machine I referenced that had rusted fabric were stored indoors.
You have the freedom to do as you will, but I am trying to give advice to folks who may not have all of the knowledge and or experience to make a call like that. Not everyone has dealt with a couple hundred antique sewing machines.
09-03-2015, 05:14 PM
#16
Super Member
Join Date: Mar 2015
Location: Denver, CO
Posts: 4,288
I always push to bring machines in the house. While humidity can be 60 percent indoors or out, a machine at 35 degrees attracts moisture like a magnet.
In Colorado it's common for temperatures to go above and below freezing in the same day. I worry about condensed water seeping into the machine and re-freezing, cracking something.
John
In Colorado it's common for temperatures to go above and below freezing in the same day. I worry about condensed water seeping into the machine and re-freezing, cracking something.
John
Thread
Thread Starter
Forum
Replies
Last Post
AngelinaMaria
Main
8
07-09-2014 03:21 PM
