How do you bind with the 1/4" foot?

Reply Subscribe

Page 2 of 2

Thread Tools

09-02-2011, 01:13 PM

#11

suebee

Super Member

Join Date: Oct 2010

Location: Arizona

Posts: 4,039

Ditto

Quote:

Originally Posted by QuiltingGrannie

I machine sew it onto the front of the quilt and then fold it over and hand stitch it onto the back.

09-02-2011, 01:18 PM

#12

bearisgray

Power Poster

Join Date: May 2008

Location: MN

Posts: 24,467

Some of the purchased, folded bias tapes/bindings were folded so that they could be applied with "one stitching"

They were folded so that one side of the "center fold" covered a bit more than the other side did.

I think these were more designed for binding things like necklines and armholes, though.

09-02-2011, 01:56 PM

#13

Melinda in Tulsa

Super Member

Join Date: Dec 2008

Location: Tulsa, Oklahoma

Posts: 4,413

After I've sewn the front down using a 1/4 inch foot, I sew the back using an edge joining/SITD foot and move my needle over a click or 2.

09-02-2011, 02:14 PM

#14

Grace173

Banned

Thread Starter

Join Date: Jul 2011

Posts: 54

Well this is all very interesting. I am going to a sew night next week in my LQS so I will bring my next binding up there for their opinions. Thank you all for your replies

09-02-2011, 03:08 PM

#15

Jessie 2

Member

Join Date: Jul 2010

Location: Prairieville, Louisiana

Posts: 93

I put double fold bias binding on with my 1/4 inch foot, I have a Janome (don't Know if that matters) There is a small hole on the left of the foot and I just move the needle until it will go though the hole and put the outer edge next to the foot and it fits perfectly.
Hope this helps
Jessie