Any ideas what mach(s) this might go to?
#1
Super Member
Thread Starter
Join Date: Feb 2012
Posts: 8,091
Any ideas what mach(s) this might go to?
[ATTACH=CONFIG]432916[/ATTACH]
[ATTACH=CONFIG]432917[/ATTACH]
I found this in some Singer stuff. It's marked MADE IN ITALY on the back side. Other than that, no markings or numbers.
It's for an end loading bobbin machine with a left homing needle. Possibly a straight stitch accessory needle plate.
Joe
[ATTACH=CONFIG]432917[/ATTACH]
I found this in some Singer stuff. It's marked MADE IN ITALY on the back side. Other than that, no markings or numbers.
It's for an end loading bobbin machine with a left homing needle. Possibly a straight stitch accessory needle plate.
Joe
#5
Super Member
Join Date: May 2012
Location: Florida
Posts: 1,585
That looks similar to the one on my Singer 328K, but I'm not at home right now -- working, so I can't swear to it.
Jeanette Frantz
#6
Super Member
Thread Starter
Join Date: Feb 2012
Posts: 8,091
#7
The BU is a ZZ. but mine came with a straight stitch plate and ZZ plate. My 403 the same. A collision can occur if One forgets to trade them out when going from SS to ZZ.
#8
Super Member
Thread Starter
Join Date: Feb 2012
Posts: 8,091
I have an ALDENS Magic ZZ machine that is a ringer for the Necchi. I'm going to pull it down off the shelf and see if this will fit it.
Joe
#9
Super Member
Thread Starter
Join Date: Feb 2012
Posts: 8,091
Ron,
Well, that about clinches it. My ALDENS Magic ZZ machine is indeed a very close copy of the Necchi BU.
The needle plate fit perfectly.
[ATTACH=CONFIG]433390[/ATTACH]
The top three needle plates came with the ALDENS, the bottom one is the one in question.
[ATTACH=CONFIG]433392[/ATTACH]
Italian needle plate in ALDENS machine. Fit's perfectly.
[ATTACH=CONFIG]433393[/ATTACH]
A close up of the Italian needle plate in the Japanese machine with the needle down and feed dogs up. Fits perfectly.
Sometime back someone mentioned this machine was a Japanese copy of the Necchi BU. That really looks to be true.
Joe
Well, that about clinches it. My ALDENS Magic ZZ machine is indeed a very close copy of the Necchi BU.
The needle plate fit perfectly.
[ATTACH=CONFIG]433390[/ATTACH]
The top three needle plates came with the ALDENS, the bottom one is the one in question.
[ATTACH=CONFIG]433392[/ATTACH]
Italian needle plate in ALDENS machine. Fit's perfectly.
[ATTACH=CONFIG]433393[/ATTACH]
A close up of the Italian needle plate in the Japanese machine with the needle down and feed dogs up. Fits perfectly.
Sometime back someone mentioned this machine was a Japanese copy of the Necchi BU. That really looks to be true.
Joe
#10
It looks very much like my BU. Mine is green which I had never seen before or since. I got it early in my addiction and paid too much for it, but it sure is pretty.
Thread
Thread Starter
Forum
Replies
Last Post
SmickChick
General Chit-Chat (non-quilting talk)
5
07-15-2011 06:47 PM