Hi All! Newbie looking for some assisance
 

Hey everyone, I just made an account here today and am super excited putting my machine to proper use-except I'm entirely new to this and can't seem to get the machine to stitch.

http://imgur.com/HKtmNyq
Thats picture of the machine, I've figured out how to wind the bobbins and load the bobbin into the shuttle. I'm not 100% on how to thread the machine and as a result (I think) the machine wont stitch at all

Anyways, any insight would be greatly appreciated as I lost and I can upload pictures if needed:o

the thread should go into a guide ----then through the tension knob -----to the thing that goes up and down ...has hole to some more guide then to the needle ....hope that makes sense and helps

Hi,

You can make out the thread path from this picture and order a manual if needed:

http://www.tias.com/173/PictPage/1922476954.html

Hopefully you have a supply of needles on hand or one to measure as it appears to be a non standard size according to ismacs needle list. Good luck with your project.

Jon

Welcome from WI.

Welcome from NE Ohio.

Cool machine! Welcome from SW Ohio.

Indiana welcomes you too.

Welcome to the board. That's a beautiful machine!

Your machine is a beauty.

Very pretty machine! Welcome to the Board where most of your questions will have answers to help you. I have learned so much from this site.