When I was working on my sister's 66-1, I printed out the "plates" for the screws from the parts list and found it to be really handy. I was pretty good about just doing one section at a time and tried to take lots of pictures. However, there were times when the screws were quite similar and by holding up to the print out, I could go to the numerical list (which starts on about pg 17) and could generally figure out where it was supposed to go. The parts list I used was the one found at
https://web.archive.org/web/20190727...rts/66-1_3.pdf
I believe it is the same one at
https://www.manualslib.com/manual/15...nger-66-1.html I printed it out "actual" size.
Janey - Neat people never make the exciting discoveries I do.
Not affiliated with off-site link(s)