i am new to the qb was wondering will the next house be listed here or will the next one be started in new topic

It will be a new topic and it will be listed on the first of February. Keep watching the BOM section for it that day. :-D

ok thanks candi

It's almost the 1st....Just 2 more days!!!! Can't wait.

I'm new to this forum and need help printing the blocks. The 1" square does not come out that measurement. How do I correct this?

On my print outs, ChurchtempsA 1" square is not as big as ChurchtempsB & ChurchtempsC print outs. If I start piecing these those two will be a little smaller and not fit. How do I enlarge it that little bit???
Thanks for any help.

When you print the template do a print preview first. Then change the scaling to either "none" or "100%" (take it off "shrink to fit" ). Hope that helps.

Even though my computer says 100%, my printer has a mind of its own. Print out then measure. If the inch is off, I adjust the size on the printer. I usually make several copies after the size is exact. I keep one for a master.

Also I have printed on Pellon quilter's grid attached to a 8.5 x 11 sheet of label stock. You can leave the Pellon attached to your square. This stabilizes your work and prevents paper pieced squares from "growing".

Also, for template A change your print from portrait to landscape. That should take care of it.

I think I must be more impatient than everyone else... will the new block be posted at 12:01 am? which time zone? :)