stitchofclass2

I am making a quilt and wanted to miter the corners of an 8" border (with pieced squares and stripes). I cut the stripes to be mitered the exact size needed only to find out that I should have cut them 2" longer. Would it be too tacky to turn one side under (as a 45 degree angel) and top stitch it? Thanks for your help.

amandasgramma

My LQS actually showed me the technique. She uses invisible thread the do the stitching. I'm not fond of the technique, but in your case it would really help you save the miters.

dunster

You can, but there might be a better solution. Since your border is pieced, can you insert a bit of fabric into the center of each side,making each side 2" longer? If not, you could iron some stabilizer onto each end of each border piece, making it 1" longer (at each end, so 2" overall), and then do the sewing. You will wind up sewing right to the corner of the outside edge of each border strip, but the stabilizer will strengthen it a bit, and when you bind the quilt that weak part of the seam will be covered.

stitchofclass2

Thank you. I thought of this too. I will probably have to do this. Hope it goes well.

stitchofclass2

This is also a good idea. Will check to see if I can piece these four pieces. After all, it is a "pieced quilt". Thank you so much for this tip.

MTS

Good suggestions upthread.

However (there's always an however),
if you did, in fact, cut it the exact measurement - iow, the length of the sides of your quilt top plus 16 inches - you should have the exact amount you need, and not be short anything.

So I would question whether your border is correctly applied to the quilt, and that your miter is a PERFECT 45 degrees first before doing any more piecing.

Because you really shouldn't be short 2" if it was all done correctly. I'm not talking like the quilt police here, I'm just saying..... ;) ;)

butterflywing

another option is to overlap, as you suggested and blindstitch with invisible thread, the same way you would needleturn applique.

dunster

The extra 2" is because if it's cut just actual border + 2* width of border you run out of seam allowance when you get to the corner.

MTS

Um, wouldn't the piece you're mitering it up with have the same issue? So they would both end the miter at the same place?

Regardless, if it was done correctly, 2" shouldn't just disappear from the length.

Just saying.

stitchofclass2

Thank you for this remedy. I am feeling much better about this already. Have to travel tomorrow so won't be quilting for a couple of days. Will post a photo when complete. Thanks to everyone who is trying to help me. I so appreciate it. Yolanda