Go Back  Quiltingboard Forums > Main
help with turned applique technique? >

help with turned applique technique?

help with turned applique technique?

Old 07-29-2009, 11:08 AM
  #1  
Super Member
Thread Starter
 
sew cornie's Avatar
 
Join Date: Jul 2009
Location: Oregon
Posts: 1,869
Default

I'm getting started on my IRR2 center block which has an appliqued floral motif. I've done fused applique before, but think the integrity of this design would be compromised by visible stitching.

After consulting my quilting books for tips on turned applique, I still have a couple of questions and would love some advice:

1. What type of pencil is best for marking applique placement on the background?

2. I've seen references to pencil-marking the appliqued piece with the turn under line, using the needle to turn as you sew. I've also seen it said to press the edges of the piece over the freezer paper, leaving that in place while stitching and then removing it just before finishing. Any suggestions for what is best for a newbie?

Thanks,
Jen
sew cornie is offline  
Old 07-29-2009, 01:43 PM
  #2  
Power Poster
 
Lacelady's Avatar
 
Join Date: Apr 2009
Location: Ireland
Posts: 12,281
Default

I use a Sewline propelling pencil, where the 'leads' are available in different colours, i.e. regular grey colour, white, yellow etc. They are similar to a fairly hard ordinary pencil, and draw with a nice fine line. There is also a propelling type holder for a length of eraser that works very well as long as you haven't pressed too hard with the drawing in the first place, though I recommend you testing it on a scrap first. If you want to needle turn, then you have several alternatives to hold the top fabric in place while you stitch. You could pin it, but they drive me crazy, if you can only do that, then I suggest you try pinning from the back, where your sewing thread is less likely to catch on all the pins. You could tack the top fabric down, which is time consuming, but that's what I did with my avatar blocks. I tacked about a quarter inch away from the sewing line, trimmed my top fabric to just less than a quarter inch where I was planning to sew, snipped the edges on curves, then tucked them under and sewed down a bit at a time. Don't trim them all at once, as they could fray, just do an inch or two ahead of where you are stitching. Then the third alternative to pinning or tacking would be the newest one to me, and that is to use a small amount of Elmer's School Glue to hold them in place. I stress use only the SCHOOL version, as that is washable (and by that, it might need two hours of soaking to remove it all, but just leave it for that time, and it should all be out). If you can get the fine tips, then all well and good, or perhaps use a fine paint brush to apply, then put in place, and heat set with an iron. The glue will hold in place while you needle turn. I hope that helps.
Lacelady is offline  
Old 07-29-2009, 01:58 PM
  #3  
Super Member
 
amandasgramma's Avatar
 
Join Date: May 2009
Location: La Pine Oregon, USA
Posts: 5,907
Default

I use the same pencils as LaceLady. But when it comes to the actual sewing, I'm kinda lazy. I use the freezer paper, iron it on the right side of the fabric, trim to within 1/4". I use little tiny pins made for appliqueing and pin them onto the base fabric. I then use a toothpick and make the fabric turn under...I keep the toothpick in my mouth and the dampness makes it grab the fabric and I turn under about 1/4"-1/2" at a time, according to the cutout. It takes practice, practice, practice to do any appliqueing.
amandasgramma is offline  
Old 07-29-2009, 03:24 PM
  #4  
Super Member
Thread Starter
 
sew cornie's Avatar
 
Join Date: Jul 2009
Location: Oregon
Posts: 1,869
Default

Thank you both so much. This is really helpful information. Looking forward to getting started! :-)
sew cornie is offline  
Old 07-29-2009, 06:24 PM
  #5  
Senior Member
 
QuiltMania's Avatar
 
Join Date: Feb 2009
Location: Southeast Michigan
Posts: 825
Default

I use a regular #2 pencil, either sharpened to a very fine point or I use a mechanical pencil. I usually trace the pencil line and fold over as I go. Freezer paper is not my friend so I tend to avoid it.
QuiltMania is offline  
Old 07-30-2009, 08:41 AM
  #6  
Junior Member
 
TEXASQUILTS's Avatar
 
Join Date: Jul 2008
Location: EAST TEXAS
Posts: 118
Default

Here is my 2 cents. Working on my first applique quilt, I used freezer paper on wrong side, used a small ironing wand and turn over the seem
with freezer paper still attached. I then basted th seams down, pressed
again very good. When stiching down to the quilts I stich as much as
possible before I remove the basting and freeezer paper from the piece,
It works for me and the pieces look very nice and clean crisp edges.

Just remember not to appliue down too much before you remove paper.
Leave a big enouch whole to pull it out. I use hemostat to pull it out.

Hope this helps.
Texasquilts
TEXASQUILTS is offline  
Old 07-30-2009, 08:45 AM
  #7  
Super Member
 
bearpaw's Avatar
 
Join Date: Jul 2008
Location: Pennsylvania
Posts: 1,635
Default

This technique was posted on another post. I thought this was such a brilliant idea!

Explanation on middle of page 8, pictures on bottom of page 8, continued on page 9.

http://www.quiltingboard.com/posts/list/105/21098.page

bearpaw is offline  
Old 07-30-2009, 09:01 AM
  #8  
k3n
Power Poster
 
k3n's Avatar
 
Join Date: Feb 2009
Location: Somerset, England
Posts: 10,686
Default

Originally Posted by TEXASQUILTS
Here is my 2 cents. Working on my first applique quilt, I used freezer paper on wrong side, used a small ironing wand and turn over the seem
with freezer paper still attached. I then basted th seams down, pressed
again very good. When stiching down to the quilts I stich as much as
possible before I remove the basting and freeezer paper from the piece,
It works for me and the pieces look very nice and clean crisp edges.

Just remember not to appliue down too much before you remove paper.
Leave a big enouch whole to pull it out. I use hemostat to pull it out.

Hope this helps.
Texasquilts
I do this exactly! And I use a regular pencil to trace the outiline. For very curved edges or circles, I run a line of stitches half way along the seam allowance and pull up over the paper then gently remove the paper before fastening off. Then I remove the basting stitches once it's appliquéd in place. And I either use small appliqué pins to hold the shape in place or baste on if the piece is very small or has a sharp point. Re folding sharp points, I fold the end first then the two sides, trimmed as narrow as I dare. Hope this helps. :D
k3n is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
mmdonnelly
Main
21
11-21-2019 05:33 PM
mjpEncinitas
Main
22
05-20-2019 04:58 AM
TanyaL
Main
9
08-02-2011 09:25 AM
sumcoop
Main
7
06-06-2011 07:16 PM
craftybear
Links and Resources
2
05-13-2011 08:50 AM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


FREE Quilting Newsletter