Go Back  Quiltingboard Forums > Main
Need to sanwich quilt >

Need to sanwich quilt

Need to sanwich quilt

Thread Tools
 
Old 04-30-2020, 05:47 AM
  #11  
Power Poster
 
Join Date: Nov 2009
Location: Mableton, GA
Posts: 11,194
Default

Originally Posted by juliasb View Post
I don't have any real large spaces here either. I find I will fold the quilt in 1/2 and work one area at a time. I have found that using Elmer's Washable School Glue is the best for my limited space The quilt does not shift easily once the glue is applied and I can roll up one side then the other. I can even fold it going the other way if necessary.
This is what I do too. I use a table and shift it around. Start in the middle and work out. I've not had any problems and it is much easier than getting down on the floor and taping.
Stitchnripper is offline  
Old 04-30-2020, 06:48 AM
  #12  
DJ
Super Member
 
Join Date: Mar 2008
Location: Pacific NW
Posts: 4,392
Default

If/when I use my bed and spray baste, I put a clean sheet over the bed quilt to protect it. Then I can just throw the sheet in the wash when I'm done.
DJ is offline  
Old 05-01-2020, 07:52 AM
  #13  
Senior Member
 
Join Date: Jul 2011
Location: New Jersey
Posts: 353
Default

I agree, I use my queen size bed. It's the only big surface I have other than the floor. If I got down there though, I'd never get up! Smaller quilts I use the dining room table.
just janet is offline  
Old 05-02-2020, 01:56 AM
  #14  
Super Member
 
Join Date: Aug 2010
Posts: 2,181
Default

Originally Posted by sewingpup View Post
ummm...don't know how big your bedroom and bed are....but could you strip your bed....carefully lay out the backing batting, and top on it....and start pinning it from the center out keeping everything straight....suggested stripping the bed just because I think it would be easier to avoid pinning the quilt to the bedding ...if you had a large enough dining table that could also be used.....I have done this method before I got my long arm as my knees are bad...
I use this method, too, but I leave the bedding on. I have a couple of older cutting mats that I've saved to slide under the sandwich so I don't end up pinning the bedding. If the quilt is larger than the bed, I start in the middle and pin well before sliding the quilt back and forth to pin the sides. I have found this method works best if the quilt back is either unwashed (iron well) or starched so that it is stiff and lays flat easily.

I also quilt larger quilts in sections, but this means pre-planning by not putting it all together before basting. Marti Michell has a book about this method that I have used.
Mkotch is offline  
Old 05-02-2020, 02:35 AM
  #15  
Super Member
 
WMUTeach's Avatar
 
Join Date: Dec 2010
Location: Portage, Michigan
Posts: 7,363
Default

Mine are just stacking up until the world, my world, settles down so I can participate in my guild work day.in June or July. I will then layer several, quilt all summer and have a pile of finishes.

An alternative is to ask a local longarmer if they would baste you quilt for you for a moderate fee. I had one done like that and it worked beautifully for a hand quilting piece that was too large for a traditional layout and sandwiching.
WMUTeach is offline  
Old 05-02-2020, 06:55 AM
  #16  
Super Member
 
Join Date: Aug 2013
Location: Florida
Posts: 5,896
Default

Kitchen counter? Ironing board? I know either are not ideal but I have sandwiched mine on my kitchen island for the height and on my ironing board a little section at a time starting in the middle. The ironing board, I can only describe as the way you would iron sheets. I'm of the generation that used to have sheets ironed. LOL.
toverly is offline  
Old 05-02-2020, 09:31 AM
  #17  
Super Member
 
Join Date: Aug 2018
Location: Greater Peoria, IL -- just moved!
Posts: 6,055
Default

Originally Posted by toverly View Post
Kitchen counter? Ironing board? I know either are not ideal but I have sandwiched mine on my kitchen island for the height and on my ironing board a little section at a time starting in the middle. The ironing board, I can only describe as the way you would iron sheets. I'm of the generation that used to have sheets ironed. LOL.
My ironing board is currently set up across the side of my couch, I often layout fabric on the couch as I iron. As I mentioned earlier, my bed and my ironing board are my largest work surfaces -- but they can be augmented! If you ever get a box that is a good shape for fitting next to your bed or couch or whatever workspace, save it by emptying it and folding it flat. It can then be put between a couch and a wall, or under a bed or some sort of out of the way place, ready to snap into action with a fresh piece of tape.

Those flat folded cardboard also make a nice work surface or again like my kraft paper can be spread out over your bed for a firmer surface or one more suitable for pin basting. Trust me, spray is ok but you don't want to pin baste on a waterbed without a few extra precautions!
Iceblossom is offline  
Old 05-07-2020, 03:29 AM
  #18  
Junior Member
Thread Starter
 
seazteddy's Avatar
 
Join Date: May 2008
Posts: 259
Default

I tried my bed but kept pinning my bed to the quilt top. They are twin size tops. I guess I will wait for the library to open up and keep making tops. Thanks for your suggestions.


Last edited by seazteddy; 05-07-2020 at 03:34 AM.
seazteddy is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



FREE Quilting Newsletter