Julienm1

So I pin baste the heck out of this lap size top. Stretch the heck out of the backing...using a sheet this time. Smooth out the batting. Lay out the top. Smooth it out too and pin and pin and pin about 3-4" apart. Using the walking foot on my DSM but has small throat or regular size throat. Machine is a Singer that I bought at JoAnns last Dec.

So now I'm quilt and the walking foot is "moving" the fabric rather than sewing over it. OMG I think I solved the problem. It was making funny noises. I think I need a new quilting foot.

Homespun

Glad you discovered your problem.

patricej

walking feet can be temperamental.
sometimes it just takes removing it and putting it back on.
it can look like it's on correctly but have something slightly "off."

bearisgray

I've had better luck when I "just smooth" the backing (and other layers) rather than stretching it - because it will "relax" and contract and cause the other layers to "pucker" a bit when it is "released".

When the backing is stretched - think of a rubber band that is stretched - when you let go - it goes back to its "usual" size.

So - if you really stretched the backing - that could be part of the problem.

QuiltinGranny2

So true, I found this out the hard way. Smooth the backing out but DO NOT stretch. Disastrous results.

Tartan

Make sure the little lever on the walking foot goes over the needle bar or it will not “ walk” and you get tiny stitches.

tropit

I had a question about walking feet that I posted in the vintage Sewing Machine section and bkay gave me this advice:


I've found you have to reduce the pressure on the presser foot, reduce the tension and elongate the stitch to about an 8.

bkay

I hope that helps.

Julienm1

UPDATE!!!---Found my Baby Lock foot...machine died and over $500.00 to fix...NOT!...Put it on the Singer...no issue. Quilting like a charm. TU to everyone who had suggestions. I had the Singer attached correctly (learned about the BAR the hard way years ago...lol)

Bear...TY for your suggestion regarding smoothing everything. I will try NOT to be a "stretcher" in the future.

bearisgray

When I put the backing on my table for layering - I do put a "light tension" on it - just enough to keep it from bunching up when I add the batting and top .

What I do - I do smooth it out - and tape the ends to the table with masking tape - and the part that hangs over - I make a temporary "pocket" and put a yardstick or curtain rod into the pocket to keep it from wrinkling on me.

MaryRinWi

I have had success laying the batting out, "seeds down" on my large cutting table. I then smooth (not stretch) the backing (wrong side down) over the batting. Next, I carefully turn it over so the backing is on the table and the batting is on top. Then I smooth the top, wrong side down, over the batting. Finally, I pin.