Squaring up blocks !!!
#2
I don't know what a gfg block is. But, for the most part you need to be mindful of the quarter inch seam that you must have on each edge for the block to set in properly. I use square up rulers to square mine up. I use the one that is closest to the size I am squaring so it is easier not to make a mistake with the right squaring size.
I place the diagonal line down the center from tip to tip (checking the numbers for the unfinished block size) you will look through the ruler and be sure to see that there is a full quarter inch above the seam allowance line at the top and on the cutting side. Then cut that side and the top, turn and do the same to finish.
I place the diagonal line down the center from tip to tip (checking the numbers for the unfinished block size) you will look through the ruler and be sure to see that there is a full quarter inch above the seam allowance line at the top and on the cutting side. Then cut that side and the top, turn and do the same to finish.
Last edited by RedGarnet222; 01-15-2013 at 11:20 AM.
#3
Power Poster
Join Date: Dec 2008
Location: Western Wisconsin
Posts: 12,930
gfg would be grandmother's flower garden, right? Octagons.
First of all, is it really necessary to square them up? I rarely need to square up blocks. However, if you really want to do it, my advice would be to draw the outline of a block (including outside seam allowance) on a piece of freezer paper, iron the freezer paper to your ironing board, then pin the block to match the outline, mist with spray starch, wait a minute to allow starch to be absorbed, then press carefully.
First of all, is it really necessary to square them up? I rarely need to square up blocks. However, if you really want to do it, my advice would be to draw the outline of a block (including outside seam allowance) on a piece of freezer paper, iron the freezer paper to your ironing board, then pin the block to match the outline, mist with spray starch, wait a minute to allow starch to be absorbed, then press carefully.
Thread
Thread Starter
Forum
Replies
Last Post