6 inch finished Bear Claw
We are making a sampler quilt at our guild..... Everyone is doing 12 inch blocks but I want to spice it up a bit... our assignment is a bear claw this month.... I would like to do a 6 inch instead of 12... finished block... Can I simply reduce measurements in half???? or does someone have the dimensions for cutting... sure would appreciate any help....
|
you would have to delete the seam allowances of each piece, then cut the resulting measurement in half. then add the seam allowance back in
|
Your paw cuts 4 1/2" and the toes and small square are 2" finished
|
1 Attachment(s)
You would cut 4.5" for the square and make 2" finished HST for the claws. Hope this helps:
|
thanks Ladies... I knew I could count on you.... you are the best.....
|
Originally Posted by ManiacQuilter2
(Post 7203651)
You would cut 4.5" for the square and make 2" finished HST for the claws. Hope this helps:
|
Originally Posted by QuiltnNan
(Post 7203636)
you would have to delete the seam allowances of each piece, then cut the resulting measurement in half. then add the seam allowance back in
|
Originally Posted by sdeaaz
(Post 7204462)
what about the strip in the middle...????? most have a sashing strip with a square in the middle
|
All times are GMT -8. The time now is 03:35 PM. |