Quiltingboard Forums

Quiltingboard Forums (https://www.quiltingboard.com/)
-   Main (https://www.quiltingboard.com/main-f1/)
-   -   Blindstitch (https://www.quiltingboard.com/main-f1/blindstitch-t2244.html)

Steve 09-11-2007 07:39 AM

So can anyone explain or better yet illustrate a Blindstitch for me? I’m getting ready to do prairie points and the back is finished with this stitch, so...

bj 09-11-2007 07:53 AM

Are you sewing by hand or by machine?

Steve 09-11-2007 07:59 AM

The article I read said blindstitch, but didn't specify. The in the ditch on top will be by a machine.

I'd like to learn to do it by hand.

Moonpi 09-11-2007 08:04 AM

Check your owner's manual for machine settings. In blindstitching, the bulk of the thread is caught on the unseen side, and just a dot shows on the surface. If you are wearing pants, chances are the hem was blindstitched.

No special tricks, just practice on some scrap first and you should be fine.

bj 09-11-2007 08:15 AM

Seems like blind stitching in quilting would be kind of like needle turn applique. I just alternate sewing right in the fold of the fabric with sewing through the backing. Tiny stitch through the back so there's only a dot of fabric and fairly small stitches in the folds. I did a search for blind stitch and it brought up a couple of suggestions. But I wasn't sure if any of them were what you meant.

zyxquilts 09-11-2007 09:53 AM

When I use the blindstitch to sew down the back of my bindings, I do it by hand. I hide the knot first, then take a small stitch into the fabric of the quilt - and only go thru' one layer. When I come up, I slide my needle thru' the fold of the binding a short way (less than 1/4"), then come out & back thru' the quilt. "Lather, rinse, repeat" so to speak! lol :wink:

Hope this helps...

lin 09-11-2007 02:12 PM


Originally Posted by zyxquilts
When I use the blindstitch to sew down the back of my bindings, I do it by hand. I hide the knot first, then take a small stitch into the fabric of the quilt - and only go thru' one layer. When I come up, I slide my needle thru' the fold of the binding a short way (less than 1/4"), then come out & back thru' the quilt. "Lather, rinse, repeat" so to speak! lol :wink:

Hope this helps...

Ditto this word for word. You already had the right idea Steve. I use that same stitch for needle turn and binding too.

Steve 09-11-2007 02:57 PM

So there isn't any difference between a slip stich and blind stitch? I'm confused.

Norah 09-11-2007 10:04 PM

'Zactly, Steve. You've already been doing it. You are even experienced!

:lol:


All times are GMT -8. The time now is 02:04 AM.