Bobbin question for Juki TL-2010 or 98 owners
I ordered some bobbins online for my Juki which looked just like what came with it. However, even though there is the indent near the center, there is no hole for the thread to go thru. Won't these just spin when I try to wind them?
I thought I was getting the real thing...guess not. Where do you get your bobbins? |
I got mine on Ebay, I don't remember who though... I got a box of 100 but they sell smaller quantities. Are you sure there's no hole? My hole is where the slit is and it was a little hard to see that there was really a hole there?
|
Originally Posted by virtualbernie
(Post 5954262)
I got mine on Ebay, I don't remember who though... I got a box of 100 but they sell smaller quantities. Are you sure there's no hole? My hole is where the slit is and it was a little hard to see that there was really a hole there?
|
Sorry you had a problem. I bought mine on e-bay and verified before hand that they would fit my 2010.They were fine., however, this was months ago and I don't remember where I purchased them. Good luck.
|
Originally Posted by nannyrick.com
(Post 5954285)
Sorry you had a problem. I bought mine on e-bay and verified before hand that they would fit my 2010.They were fine., however, this was months ago and I don't remember where I purchased them. Good luck.
|
Well, if you get no satisfaction from the seller, you can partially wrap the thread around the bobbin while leaving a tail to hold on to, then after it gets established, you can stop and cut the tail off and resume winding...
|
The bobbins I have for my 98Q have the slit, that's what I put the thread through.
|
I got a response from the seller and will be returning the ones I got. I just ordered some from another source.
Thanks for the feedback. |
All times are GMT -8. The time now is 12:46 AM. |