Quiltingboard Forums - Fusible batting- a small problem

Quiltingboard Forums (https://www.quiltingboard.com/)

- Main (https://www.quiltingboard.com/main-f1/)

- - Fusible batting- a small problem (https://www.quiltingboard.com/main-f1/fusible-batting-small-problem-t282357.html)

Fusible batting- a small problem

I have a Hobbs queen size fusible batting but no directions. I need to know what the iron temperature should be (cotton, rayon?) and how long to press it. Help please.

This what Hobbs had to say when I googled it...

Layer your quilt top, batting and backing. To fuse all three layers of your quilt at once, set iron on a wool or cotton setting with steam. Simply press quilt from the center to the outer edges. Be sure to keep your iron moving, pressing approximately 2-3 seconds in each area.

FAQs - Hobbs Batting

<cite class="_Rm" style="color: rgb(0, 102, 33); font-style: normal; font-size: 14px;">www.hobbsbatting.com/resources/for-quilters/faqs/

Watson</cite>

I have used Hobbs 80/20 fusible batt. I use a dry iron set on cotton to fuse. I have old carpet on my basement cement floor that I use to lay the quilt out full size. I put down the backing, ( iron its first to remove any wrinkles)smooth the batt over it and then the top. Working from the center outwards on the top, I press for about to the count of 10 and then move the iron to the next spot. It takes a while and I wear knee pads as I crawl around on the floor.
After the top is fused, I flip the whole sandwich over ( it kind of holds together now) and start ironing the back from the center out again. I usually have some wrinkles to work to the edge. After the back is fused I place safety pins around the edge about every 5 inches so I don't catch the edge while moving the quilt around.
The reason I do the back last is so it is perfectly flat because I can't see it while quilting. You will notice a few wrinkles in the front after ironing the back but they smooth out as you quilt and if necessary you can move any extra fabric to the edge as you quilt
Thanks for the link Watson, apparently I have been doing it wrong although I have not had any problems. It said steam and only 2-3 seconds in each spot. I figured since the fusible is water soluble, too much steam might make it less fusible.

Thank you both so much for the information.

yep, it's easy. only once had a bad bag. took me one hour to unstick it all when taken out of the bag. ended up with a hole even with all that work. emailed Hobbs and they sent me two bags!! never had another problem.

I have found that the fusible batting has been rather temper mental when I have used it. I've never been sure if was me or the batting. LOL

Thanks for the information on this, perhaps my next try will be easier and more successful.

I've even used June Tailor's fusible. worked well enough but must pick globs of glue off before using the batting. not fun, no longer buy hers. Love Hobbs 80/20.