I have a small 10 inch cut"n press where you can cut on one side and press on the other side the pressing side is really dirty how do you clean it I love using it because then I don't have to drag out the ironing board for little pieces please help!!!! Thanks
I know someone will have the answer this Quilting Board knows everything love it

I am wondering the same thing. Thank you for asking this question.

I think this should help. Not sure, but check it out. All I did was google it. Get some great tips from google. Also try about.com.

http://www.heidelberg.com/www/binari..._up_and_go.pdf

Sewfine

Might try some foam spray on rug shampoo? just a thought...crafty_linda_b

Mine is so old, I finally covered it and used gorilla glue to glue it back, good as new. Love it.

Mine was in pretty bad shape. I decided there was nothing to lose by trying to wash it. I used a laundry detergent/water solution and sponged it on. Then I scrubbed it with wet terry cloth. For tough stains I used a scrubbing brush. Then I used my hands to squeeze out all the cleaning solution I could, rinsed under running water and squeezed until it ran clear. I thought of using a rolling pin to squeeze out the water but didn't. After that I hung it outside in the sun to dry. I had thought about re-covering but decided to try this first. It actually came out pretty good.

Ya know...that's really not a half bad idea.

I think I'm going to try this on one of my really disgusting boards and see what happens.

Thanks for the thought. :thumbup:

I have several pieces of left over muslin that I just pin to it and replace when needed.