|
4 Attachment(s)
A few pictures of my working on my Machine Lift being installed.
Still not finished..... I need to have a custom made plexi glass made for the top of the table. I would like to have it cover the entire table, so I can turn it around and it will cover the hole when I push the machine down for storage or use for a table when cutting fabric. measure and remeasure [ATTACH=CONFIG]186557[/ATTACH] added brace under the table where the machine goes and also from the back of the desk and also braced from the floor [ATTACH=CONFIG]186559[/ATTACH] My son cut the hole for the machine from one of my computer desk [ATTACH=CONFIG]186564[/ATTACH] Almost done This plexi glass is from my other machine, I want this new one to cover the top of the desk. I also need to paint the edges and braces. [ATTACH=CONFIG]186565[/ATTACH] |
Wow, that is looking good. I'm envious.
|
That is terrific! Enjoy!
|
You certainly are going to love that!!
|
I'm saving up for the lift, they are so expensive
|
You will really appreciate being to tuck the machine away when you need space. The cabinet I bought for my H/V came with one. It is so awesome! Sure beats taking it off, and lifting it back up.
|
My brother is a cabinet maker. For years I wanted him to build me a sewing desk. I finally got it last year.....with the machine lift. They are awesome!
|
wish I had went ahead & had one installed. Great job! maybe make it wide enough to use as a light table too when you put plexi glass in
|
Lucky you! What a sweet DB :D:D:D
|
We got this one from Rockler.com for 159.00. Plus tax. Then there was the cost of the screws, brace board. 20.00
I already had the table. So, your looking at 200.00 for something you've always wanted. I can't wait to clean up the room so I can use it. I've been pinning and spraying, (taking over my kitchen counter)getting quilts ready to quilt this past week. I have 3 ready, 2 more to go. Syl |
Wow. that does look good.
Sewfine |
Wow! You're really going to love this when it's done!! Lucky you!
|
Thanx so much for showing the *in progress* installation .. that is such a great help for DIY-ers like me. This just went to the top of my wish list ... thanx again & I know you're going to enjoy yours so much.
|
You could also try what the newer sewing cabinet makers are doing. They now put a small trim piece about 1/4 below the table height and the plastic insert rests on this flat with the bed of the table. So ... the cabinet closes neatly with the table in place.
ali |
It looks great!
|
| All times are GMT -8. The time now is 03:13 PM. |