My longarm just stopped!! Light is on, thread in the bobbin, nothing in the way. The wheel will turn and the needle will move. No idea what happened. Please help.
|
Did you turn it off, wait a couple of minutes and turn it back on?
|
Try turning it off then back on again.
|
I always just turn it off and turn it back on again if anything like this happens and that does the trick. I know it sounds silly but it might just work. Did you try that yet?
|
Make sure all your cords are plugged in. My light is separate from the machine.
|
Ha ha ha 3 replies at the same time turn it off and turn it back on again :)
|
check wires might be tangled under machine suport board along the stainless steele bar it rolls on
|
There is one wire underneath the machine that is disconnected, but I have no idea how to plug it back in. Is this something I can do, or do I need to call the repairman?
|
I'm pretty sure I know how I did it, and won't repeat that. I did not keep the machine between the bungee cords and I think that's what pulled it out.
|
somtimes my long arm plugein on machine works loose needs to be pushed back in machine.
|
All times are GMT -8. The time now is 07:51 PM. |