Nesting a desidgn
 

I'm trying to "Nest" a design. When I get the design to "nest" it stops short of the right margin. Am I choosing the wrong "nest" spot? Or??? QSCII robotics.

Can you post a photo. it really helps? The old saying goes: a photo is worth a thousand words.

You might also need to stop your stitching 1/4 inch from the edge so the seams can go either way.

Here is a photo of my quilt top. It is a charity quilt, but still I am trying to learn some of the possiblities of my QSCII longarm. The other photos are of the practice quilting. The vertical lines approximate the width of the center rectangle, which I would like to quilt. I planned to do the same wave design in the red borders, but on a larger scale and only one line of pattern on each border. The X on the practice quilting is the "nesting point" that I chose, but you can see what happens on the left and right margins--so something is not right! I have even considered removing the borders and quilting the rectangle, but then I would be left with a mess on the backing. Thank you VERY MUCH for any help!![ATTACH=CONFIG]486370[/ATTACH][ATTACH=CONFIG]486371[/ATTACH][ATTACH=CONFIG]486372[/ATTACH][ATTACH=CONFIG]486373[/ATTACH]