Piecing Borders to Quilt Top
I would like to get your opinion as to how I should piece together a 5" border for the sides of a quilt I am making. The lengthwise measurement is 64" and the binding is cut in 45" pieces. Here are two ways I am considering using:
A. Add 19" to the 45" using a diagonal seam. This means that each side would have a seam about 2/3 of the way down. B. Cut two of the 45" pieces into 32" segments and sew together with a diagonal seam. This way the seam would be right in the middle of the lengthwise piece. The choice is a matter of appearance, obviously. I am sort of leaning toward option B. What do you think? |
I agree I would go with B
|
Ditto. I agree.
|
I think it really depends on the fabric.
If your choice of border fabric is a solid/blender type, and will be densely quilted, it really doesn't matter. The seams will disappear either way. If it's a print pattern where it will be very noticeable (and you didn't have enough yardage to cut the borders lengthwise), I'd go for the option that is more pleasing to the eye. And if that means I have to do a straight seam, instead of a diagonal, because it looks better, or I'm trying to match the pattern up, then I would opt for that. Because of fabric shortage (poor planning on my part), I have had to hand stitch the strips to match the pattern - I fold it over and "applique" it to another strip so I'll have the needed length for the border strips. Almost impossible to see the seam line. |
I'm totally confused, because you've mentioned binding and borders, and I'm not sure what the binding has to do with the borders.
|
oops! My bad! I meant borders instead of binding. I've been up since 3:30 but my brain is still dozing. lol
|
The reason I cut crosswise is because the directions specified that direction. The directions have had a few other weird layouts, as well.
|
Originally Posted by MTS
(Post 4640379)
I think it really depends on the fabric.
If your choice of border fabric is a solid/blender type, and will be densely quilted, it really doesn't matter. The seams will disappear either way. If it's a print pattern where it will be very noticeable (and you didn't have enough yardage to cut the borders lengthwise), I'd go for the option that is more pleasing to the eye. And if that means I have to do a straight seam, instead of a diagonal, because it looks better, or I'm trying to match the pattern up, then I would opt for that. Because of fabric shortage (poor planning on my part), I have had to hand stitch the strips to match the pattern - I fold it over and "applique" it to another strip so I'll have the needed length for the border strips. Almost impossible to see the seam line. |
Likewise, if it were later in the morning I would probably have understood your first post. LOL
It's quite common to have to piece your borders. I usually go with a straight-across seam, because it's easier, doesn't use the bias, and almost always looks just fine after quilting. In most cases it really doesn't matter at all whether it's in the middle, 1/3 of the way down, same place on right and left, etc. If the fabric is a true border fabric, or if it's a large print, I would try to match up the pattern, otherwise I wouldn't worry about it. After all a quilt is made of many seams. |
Piecing Borders to Top
Thanks, everyone! You are pretty much confirming my opinion. I am glad to see the suggestion for a straight seam, which I would prefer to do. On the thinner inner (I rhyme!) border I cut the pieces so the seam matched the seam of a block on the edge of the quilt. That way it was just a continuous line and less noticeable. It took some trial and error but it is worth it, imho.
|
All times are GMT -8. The time now is 02:22 PM. |