Queen Supreme Super Slider?
 

I was just about to order one of these but I'm not sure if it will be to big for my machine. I have a Pfaff 2140. Can anyone tell me how many inches it is from the hole to the edge of the slider. My machine is 7 inches from the needle to the sewing machine. Any help would be greatly appreciated!

I have the regular size and the cut out hole for the needle is in the center. I'd assume the same for the queen size.

Ad says slider is 11 1/12 x17. It might be tight but the center of 11 1/2 is a tad less than 6 inches.
Do you have a table or is the machine inset? The 17 inch length could be a problem.

I don't know the space from side to needle cut out, but if you have enough room on the other 3 sides, you could always trim that one edge?

I have a Queen Supreme Slider. The hole is not centered in this size slider. The following measurements are to the center of the hole.

When the slider is oriented horizontally (so the length is running left to right), the hole is 6 7/8" from one side and 9 7/8" from the other.

If the slider is oriented vertically (the length running front to back), the hole is 5 3/4" from either side.

I have a Pfaff Performance 5.0. When I place the Slider horizontally with the 9 7/8" to the right of the hole, it fits perfectly.

Two other less expensive options you might try are:

http://forum.missouriquiltco.com/loo...esome-fmq.html

http://thequiltrat.blogspot.com/search/label/sew%20slip

I recently bought an oven liner and plan to give the first option a try as my machine is in a cabinet with a plexiglass insert (like the original poster) and I wanted to cover the entire area too.

Hope this helps.