Sos
I cut all my strips out for my rail fence using three colors. I cut 2.5 x 6.5 strips and now Ive got a mess with my blocks going together..what do I do???? Ive got a perfect 6.5 across but short 1/2 inch when I turn the block.
|
Check your seams, they may be off. Easiest fix is to cut the blocks down to the smaller size square. You can always adjust any border size if you need to make up the difference in the overall quilt size.
|
When that happens to me it is usually that my 1/4 inch is not a 1/4 inch but a ooch more. If you haven't checked that, then I would and maybe that is the problem, like Katier said.
|
Deja vu. Did the same thing on my very first quilt.
|
As little as an eighth of an inch difference on each seam will resuilt in loss of a half inch. Remember, two pieces of fabric shortened by 1/8 equals a quarter inch each seam.
|
is that the right size width of strips then..2.5 x 6.5? Im only using three colors of blue.
|
Rail fence blocks can be any size. If you are shooting for 6 inch finished blocks, then 2.5 x 6.5 should be right. The only explanation I see is your seam allowance.
|
Yes, it's the right size. Each strip will be 2" wide when finished. As a block (before the blocks are put together) the two outside strips will still have .25" seam allowance on one side, so the total unfinished width of the block will be 2.25+2+2.25=6.5.
Originally Posted by honeybee_2000
(Post 5954267)
is that the right size width of strips then..2.5 x 6.5? Im only using three colors of blue.
|
Such wonderful explanations from all!!!
|
well they must be square to fit. measure them all and trim all to one size. good luck.
|
All times are GMT -8. The time now is 01:05 AM. |