18-Degree Squedge Table Topper
 

[ATTACH=CONFIG]546787[/ATTACH]

I have made square Squedge blocks before, but this was a first. This is birthed not bound. It was supposed to have 8 points. You could say I made a design decision or that I wasn't paying attention when I picked up the wrong squedge, but I like the 10 points better. That is my story and I am sticking to it. I tried to use stack and whack but it isn't possible for them to be identical because the border print was asymmetrical and the squedge has to be flipped for half the points so this is as close as I could get. Flipped it and then appliqued the circle on and a quick quilting job of following the lines. Pretty quickly done. Have a great week.

[ATTACH=CONFIG]546827[/ATTACH]
The computer man worked for hours yesterday to enable me to upload the photo. Obviously, it didn't work. So here is my second try.

that is gorgeous!!

very nicely done

It looks great!

I would stick yo my story if I were you. It is gorgeous!!

very nice job!!!

Great topper! It came out correct, (you must have grabbed the wrong ruler) a circle has 360 degrees, divided by an 18 degree ruler you get 20 wedges, or 10 points. A 22.5 degree wedge would give you 8.

that topper came out beautifully.