How many layers do I need?
 

I am making potholders for a fundraising event and can't remember how many layers I need in my sandwich. Do I use Insulbrite, muslin, and batting or just Insulbrite and muslin? Does it really matter? These will be quick potholders made from a panel or single piece of front fabric and a backing.

Thanks for your help.

I use a layer of batting and insulbrite and the backing.

I put insulbrite between two layers of cotton batting. Anything less and there is a chance of heat coming through.

I use frint, cotton batting, Insulbrite, backing. Others may differ.

Old terry cloth towels make wonderful "fillings" for potholders -

I try for enough "filling" to make it heat resistant - but not so much that the potholder won't "bend'

I can't say how many layers of terry cloth, because that varies so much from towel to towel.

Tartan-this is how I make potholders and they seem to be the best way without too much stiffness to them. Good luck on your project

I don't really make potholders, but have a curiosity question. My knowledge of insulbrite is that it has one shiny side... and this shiny side is to reflect heat. If you put that between two layers, how does one know which side is reflecting the heat?

I always have to test the insulbrite to make sure i get the side i want where i want it.

Doesn't make a bit of difference when layered. I have potholders made with the Insulbrite turned each way. Think about it. Either way it's turned your hand will shielded from the heat.