Quiltingboard Forums - fabric pouch tutorial

Hope you can all understand my directions ! Here goes...........

Make yourselves a paper template - 1 sheet of A4 paper is big enough. (Picture 1 )

Place on fold of fabric . Pin . Cut 1 in choice of fabric and 1 in lining fabric.

Take a 14 inch piece of ribbon fold in half and thread through the small hole on a curtain ring. (Picture 2 ) Pull ribbon through its self and pull tight.

Place on right side of fabric about 1.5 inches down from where triangle begins (Picture 3 )

Turn to right side. Cut a piece of card 2 inches x 4 inches approx and cover with fabric. ( I use spray adhesive ) Allow to dry .

[ATTACH=CONFIG]104127[/ATTACH]

Spray back of covered card and place in base of pouch .Finished !

[ATTACH=CONFIG]104128[/ATTACH]

Template

[ATTACH=CONFIG]104511[/ATTACH]

ribbon / curtain ring

[ATTACH=CONFIG]104512[/ATTACH]

position of ribbon on fabric

[ATTACH=CONFIG]104513[/ATTACH]

Pin all together leaving a small opening to turn.

[ATTACH=CONFIG]104515[/ATTACH]

Snip fabric at internal V for ease of turning.

[ATTACH=CONFIG]104529[/ATTACH]

Turn right side out and press.

[ATTACH=CONFIG]104533[/ATTACH]

Ensure your ribbon overlaps edge of fabric. Place lining , right side down on top. Fold ribbon back over lining and pin in place

[ATTACH=CONFIG]104603[/ATTACH]

Fold ribbon across fabric fold pouch over.

[ATTACH=CONFIG]104604[/ATTACH]

Stitch from top of straight edge to base. Fold as shown and sew across the triangle at base to form a squared bottom.

[ATTACH=CONFIG]104605[/ATTACH]