Quiltingboard Forums

Go Back  Quiltingboard Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: DebJMills
Showing results 1 to 5 of 5
Search took 0.00 seconds.
Forum: Main
01-30-2023, 07:34 AM
Replies: 19
Views: 2,237
Posted By DebJMills

She didn’t trim off a lot so trying to keep it...

She didn’t trim off a lot so trying to keep it close to square. If you are off by more than 1/2 inch, your blocks will end up being smaller once you square.
Forum: Main
04-13-2021, 08:45 AM
Replies: 28
Views: 3,216
Posted By DebJMills

There is a slit in the bottom plastic of the So...

There is a slit in the bottom plastic of the So Fine cones to pull the thread through. Turn over the unopened cones and you should be able to see where the thread is secured.
Forum: Main
08-17-2020, 04:50 PM
Replies: 35
Views: 5,642
Posted By DebJMills

Agree with Jordan Fabrics tutorials - they were...

Agree with Jordan Fabrics tutorials - they were very helpful. I made one using 8 pieces and had trouble with the center of the block not being flat. I had success when I started stitching the pieces...
Forum: Main
08-17-2020, 04:39 PM
Replies: 38
Views: 4,827
Posted By DebJMills

Joann’s had a pattern posted on their site with...

Joann’s had a pattern posted on their site with lines indicating folds. The pleats are more of a z fold so while there are a few layers, it isn’t 12. If you have a walking foot, that helps go through...
Forum: Main
07-09-2020, 09:37 AM
Replies: 14
Views: 2,183
Posted By DebJMills

If you have a table that needs to be higher, use...

If you have a table that needs to be higher, use bed risers under the legs. Depending on your height may bring to comfortable cutting height.
Showing results 1 to 5 of 5


 
Forum Jump

FREE Quilting Newsletter