Originally Posted by
gump51
Brand new mat, Accuquilt Go and the arrangement of the die is already angled. It's got me stumped!!! Use the same fabric with a different die....no problem. Cuts smoothly and without much effort.
Then I agree with the other posters. Contact Accuquilt, the blades may not be fully seated in the plastic base, making the die a bit tall. I've been dealing with Accucut for almost 20 years and have had stranger things happen with them, but they have always been great at correcting the problem. Until you get a reply from them, see if you can angle the die to go thru with the cut square at 45 degrees, so a point of the square goes thru first & try a used pad, which is thinner than a new one. Might need to put a piece of copy paper between the fabric & pad for a clean cut.