Originally Posted by
Writergrrl
I'm so excited! I've just scored a new-to-me sewing table with electric lift (similar to a Horn 2156) on Craigslist! Now I'm trying to figure out how to build or buy an insert that will make my Janome 6600 flush with the surface of the table. The previous owner's insert was for a Bernina.
The cabinet is older and she did not know the make or model number. Should I just measure it and see if Sew Steady can make me a custom acrylic insert based on measurements of cutout and machine? Has anyone done this? Or is there any way to make one myself?
I have a "Craig's List" sewing cabinet and just recently purchased a new Elna eXcellence 720. I put some books and rubber matting I had under the machine to lift the bed up and then fit the table that came with my machine on WITHOUT the legs. I had to tape down the outside (left) edge but it is working wonderfully well. I took a couple of pictures but don't think I can attach them to a quick reply. I'll post them separately.